The network_reset stick resets the network configuration and WiFi passwords, and also restores the configuration files that might be corrupted. This means that the Mr Beam II switches to Access Point mode.


It can be found in the Downloads section of Mr Beam's web page.

How to use them: 3 easy steps

ATTENTION: Any running laser jobs will be cancelled.


1. In a USB stick: create a folder called mrbeam and copy the SIG file there.
Requirements for the USB stick:
  • at least 100 MB free disk space
  • USB 2.0 compatible
  • FAT32 formatted
  • Only one SIG file on the stick
  • Please read this article for more details
2. Plug the USB stick into your Mr Beam II. After a few seconds you will see a white light pattern.
3. Once the Mr Beam II switches to bright green light, unplug the USB stick.

Estimated run time: < 30 seconds.


Done! Your Mr Beam II will restart now, after that you can start to use it again by connecting in one of the following ways: 

  • Via Ethernet cable.
  • Via WiFi Access Point: connecting to the network MrBeam-XXXX (your Mr Beam II's name) with the password mrbeamsetup.

Do you need more help? Please check our Support Stick Troubleshooting Guide.