This page gives you the latest updates about the Mr Beam Software Channels.
It's meant to be updated constantly. So come back frequently when you're using our beta channel.
Hint:While you're on the beta channel in the Mr Beam Software, you can always check the latest updates on this page by clicking on the "BETA"label in the software.
What's new in the stable channel:
Release v0.15.1 MrBeam Plugin:
- Fixed:
Calibration marker engraving issue
Added:
Unpowered Air Filter 3 screen notification
Glitter Felt material settings
General improvements
Release v0.15.0.post1 MrBeam Plugin:
- Fixed:
the maintenance percentage of the air filter will jump to 100% and a reset of the data will jump again 100% again after restarting the device
Release v0.15.0.post0 MrBeam Plugin:
- Fixed:
- Laser head missing notification
Release v0.15.0 MrBeam Plugin:
- Fixed:
- Crash after quicktext beginning with “..” was used
- Quicktext font didn’t load
- Wrong triggered bottom open malfunction
- Added:
- support for Air Filter 3
Release v0.14.1.post2 MrBeam Plugin:
- Fixed:
Malfunctions 1014 and 1030 triggered on device start
Release v0.14.1.post1 MrBeam Plugin:
- Fixed:
Missing final dust extraction after job was done
Release v0.14.1.post0 MrBeam Plugin:
- Fixed:
Wrong reported fan not spinning error
Release v0.14.1 MrBeam Plugin:
- Added:
Material settings updated
Text changes and translations
Release v0.14.0.post0 MrBeam Plugin:
- Fixed:
- Compressor warning on non dreamcut devices
Release v0.14.0 MrBeam Plugin:
- Added:
- New material settings.
Improvements for high temperature warning.
Improvements for hardware malfunctions.
You have feedback about our new software updates? Then send us a ticket via our ticket system: www.mr-beam.org/ticket
It is best for us if you attach files, G-codes, videos or photos. That way we can help you as quickly as possible.
Have fun with lasering!