Technical specifications

What type of laser is used in Mr Beam II?
Mr Beam II uses a blue semiconductor laser.
Wed, 18 Jul, 2018 at 7:47 PM
How long does the laser last?
An expected usage time (= life time) of the laser is 10.000 hours. The life time doesn't decrease while you're not using the device.
Wed, 18 Jul, 2018 at 7:47 PM
How does Mr Beam II get power?
Mr Beam II is powered with 110-240V, power consumption is 65W.
Wed, 18 Jul, 2018 at 7:47 PM
What kind of files can Mr Beam II process?
Mr Beam II can process SVG, JPG, PNG, GIF, BMP, PCX and DXF. Pixel based graphics (JPG, PNG, BMP, PCX) can be engraved but not cut.  Vector graphics (S...
Mon, 1 Jul, 2019 at 2:55 PM
Which wavelength does the laser have?
The laser has a wavelength of 445nm.
Wed, 18 Jul, 2018 at 7:47 PM
What tensions does Mr Beam II support?
Power supply supports all voltages (power supply is replaceable).
Wed, 18 Jul, 2018 at 7:47 PM
What is the spot size on surface?
The spot size is 0.2mm.
Wed, 18 Jul, 2018 at 7:47 PM
How often does the laser need to be serviced? Are there any wearing parts?
There should be a small maintenance now and then, the ruler bearing needs a few drops of oil and the floor could be cleaned as needed. Our laser diode has a...
Wed, 18 Jul, 2018 at 7:47 PM
Are there filters to be changed in the filtration system? If so, how often do the filters need to be changed?
Our filter is a 3 element system, combining a pre-filter for rough particles with a HEPA filter and an activated carbon filter. The filters need to be ch...
Wed, 18 Jul, 2018 at 7:47 PM
What is the working speed for cutting/engraving?
The speed is material dependent and ranges from ~60mm/min (cutting 3mm Kraftplex) to 1000mm/min (cutting 2mm felt). Engraving ranges from 100mm/min (anodize...
Wed, 18 Jul, 2018 at 7:47 PM