Neues Thema starten

How to cut thik Paper?

I'd like to cut some thicker paper. It is a white cardboard (160 grams per square meter).

With the default settings this also works halfway, but ugly brown edges appear at the cut edges.

Is there a way to correct this by changing parameters or is the paper simply unsuitable?

Does anyone have any experience with a more suitable box that can be used to make pop-up cards?



1 Person hat diese Frage

"Does anyone have any experience with a more suitable box that can be used to make pop-up cards?"


Sorry, I meant "cardboard", not box...



 From what I've observed up to now: Burns tend to occur when too much energy gets transfered into the material. What default setting did you try? Did you try anything else?

I'd say: go faster with less energy. Repeat more often.


Daniel

I have tried several combinations of lower intesity an higher speed. It is always the same problem: Either nothing happens at all, the thick paper doesn't even get a scratch. Or a dark line of charred paper is created whichs persits after cutting is completet after several passes.

I will probably have to look for another paper or another white cardboard with about 160-250 gpsm meter...

Anyone got any advice?

I just cut cardstock (216 gr - Stampin'up brand) light blue color with the following settings: not to much dark lines all around compared to white paper


image


Scoring lines on paper settings : I have tried these that work - of course there is a dark line, not cut and good to fold - just put the paper on the wrong side so the dark line doesn't appear :


image


My first attempt of papers cuts : I took parameters by default for paper with 2 passes - the only issue is the dark lines especially on white paper - you finish by getting your fingers dirty and put dust on your paper... I cut the blue tag on the wrong way in order to avoid dark lines on front


image



2 Personen gefällt dies

Just did some paper cutting because Christmas is getting closer.

I cut 250gr/m^2 paper (white, glossy) with 90%, 600 mm/min, 4 passes. Gives a clean cut (with scorched edges).

Before removing the paper I blow of the ash.

Thus, the danger of creating ash traces on the paper is reduced significantly.

Also, instead of manually removing the cut pieces I tend to blow them out (pressurized air).

And if all failed (=ash dust marks on paper) I just get some spray paint (silver/gold/fake snow) and paint it over for a nicer look.


Anmelden oder Registrieren um einen Kommentar zu veröffentlichen